Recent content by VAV

Thank you kindly, John.

Hi John - Attached. This .mdat contains only the two original measurements being used in the Alignment Tool: L Main Timing Take II 92 and L Sub Timing Take II 96. Thanks.

I was able to reproduce this again from Reset all, and I think this better identifies the issue. I clicked Reset all, aligned phase at the 60 Hz cursor, which resulted in -3.45 ms, and then manually overrode the Delay field to +4.0 ms. As shown in the attached screenshot, the Delay field...

One additional observation seems important: this does not appear to be merely a sign-convention issue. I entered +4.0 ms manually in the Alignment Tool. The Delay field clearly displays +4.0 ms, but the distance readout immediately beside it remains -1.544 m (-5 ft 0.8 in), which corresponds to...

One further clarification that may be important: I repeated the +4.5 ms test and captured the Alignment Tool before generating the sum. The Delay field clearly shows +4.5 ms, while the corresponding distance shown alongside it is -1.544 m (-5 ft 0.8 in). After generating the Aligned Sum...

I found an additional clue that may explain the problem. I created Alignment Tool sums at different manually entered delays and named each generated measurement accordingly. For example, “Verified Take II L (+0.5ms) Aligned Sum 60Hz” and “Verified Take II L (+4.5ms) Aligned Sum 60Hz” should...

And here's the .mdat file.

John, I think I may have run across an issue with “Export all measurements as text” in REW V5.40 Beta 135. I created a series of Alignment Tool sums using the same main/sub measurements, manually changing the sub delay for each sum. The resulting measurements were saved and individually named...