Recent content by travman83

All, I'm try to understand what is happening to my frequency response (and why) with Audyssey employed using a MultiEQ filter frequency range cutoff of 300 Hz (using the editor app). My understanding is no changes should be made above ~300 Hz when Audyssey is active, but I'm measuring what...

Lots of helpful comments here, I appreciate it. Based on some recommendations, I moved the mic forwards and backwards and did notice a shift in the null. I ended up moving my seating position back a bit, which brought the null down enough to where I was able to address the issue when adding my...

Good tip. Just did that test and everything checks out phase wise. I’m not sure what’s left to do other than tame the wall reflections.

They appear to be correct. Although maybe it’s possible one of the drivers is wired with reverse polarity in the speaker?

Thanks, Sonnie. Good point! What drove me down this path was I noticed an audible drop in the bass region when listing to music, which didn’t show up in any of the individual speaker measurements. So I then decided I would measure both simultaneously to see if something funny showed up and got...

Hello everyone, I've been tinkering with my HT audio for several months, but this is my first time posting. I have taken some REW measurements for my FR, FL, and FR+FL speakers from the MLP that are stumping me. These measurements are post-Audyssey and without subs. The speakers when measured...