Recent content by tonelabaudio

Prometheus

@sm52 Hello. My apologies for not getting back to you sooner. I am in the middle of building a new Audio PC. I haven't done this in decades and it has proven to be quite the challenge. As a matter of fact I have made the comparison. Perhaps, my aging ears are failing me. But, I honestly do not...

@sm52 Perfect. Thank you. Much appreciated

@sm52 Believe it or not I took the measurement with the thick blanket in place but never sat down to listen the effect when playing music through the speakers. I will do that tomorrow. Note: Can you tell me what limit setting you used to achieve the Spectrogram images that you attached in your...

@sm52 No, you are the one to be congratulated. You are the only one on this "REW Community Forum" who reached out to help. That amazes me. Thank you

@sm52 I took your advice and tried a little test today. I took a very thick moving blanket and placed it where you had placed the yellow circle in the photo. What do you think of the new result?

@sm52 Good morning. Now that you point out that large bare area on the desk I can see how that can result in some undesirable reflections. I just want to be clear. Are you suggesting that the speaker remain flat on the desk provided I use some form of decoupling mechanism. Should I not be...

@sm52 Are you referring to the red absorber or the one behind the speaker with the leopard pattern?

@sm52 I forgot to mention that I also have speaker stands. But, there is no place for them in my small space. K&M 26740 Speaker Stands

When placed directly on the desk I found that the tweeters were firing clear over my head. It is a little primitive but I use a Bosch laser level that I have. To be honest I did not hear much of a difference in the low end. Then again, I have only started using the speakers and the room about...

@sm52 Good day. I was wondering if you would be kind enough to look over my latest measurement. Please let me know if you spot any anomalies I took my near field monitors off of the IsoAcoustic stands that I had them sitting on. Thank you in advance. Your time and assistance is greatly...

Thanks again for taking the time to assist me. I will verify the settings at each cabinet. I will also redo the measurements.

@sm52 First off I want to thank you for chiming in. I appreciate it very much. My Focals were purchased in May 2019 and have not been repaired as far as I know. I am wondering if the high frequency issue that you speak about could be inherent to this particular model. Is this something that you...

Anyone?

I would also like to add the steps that I took prior to taking the measurements: Place mic directly where my head is in 3D space at the listening position Point mic perfectly at the midpoint between the tweeter and the woofer oriented horizontally Startup REW – UMIK-1 detected – load...