Recent content by Teerhand

Yes, that is what i was counting on, also my sub (krk10s v1) doesn´t do much below 30 hz really, but that downward slope starts earlier as it seems, according to their response curve. If i would assume a 2,5 db deviation between 100 and 30hz i could live with that, until i decide i want to delve...

http://www.samsontech.com/samson/products/microphones/usb-microphones/meteormic/ this one its a cheap usb condensator mic, that i had lying around (its advertised as having a relatively flat response though...)

Ah ok, i didn´t know that, but i moved my whole Desk around the room and measured the best response (also switched phase back to 0) and i found a position for the sub where no dips occured and REW EQ only proposed three Filters, sounds pretty amazing now. I seem to have caught only the elevated...

your replies gave me some motivation, to reconsider subwoofer placement, and i moved my desk as well. so i did this till i had only peaks and no dips below 100hz (i really don´t trust the mic enough to go much beyond that, and the power of the sub poses the biggest problem anyway) With the new...

Hi Matthew, my gear is in a 3x3 m Listening Room, and while with such a bad architecture two subs would probably be my best bet, i really want to keep it simple, though, and doors and patio with big windows really doesn´t allow a lot of placements neither. I moved the sub right next to my...

Hi John, thanks for replying! I have some questions to clarify what you wrote, if you dont mind. Is applying smoothing the right thing to do? is 1/24th ok? So what value do I adress to individual max boost then? i´m a bit shy, working with this, allthough my sub should have enough headroom...

So i have been tinkering with REW for a couple of Months now, with devastating Results in the Beginning, because i don´t know much about Eqíng at all. My first Targets in REW were set much too low, resulting in no Bass at all (No Bass, no Problem with Modes though :) Then later on i managed to...