Recent content by srossi

I was never able to uninstall but I did install to a different directory and that worked. I deleted the original directory. Thanks again for your prompt help. PS - I watched your interview - It was good to put a face to your name. The video was enlightening on the origins and maturation of REW

John Thanks for your prompt reply. No luck with the procedures in the link you provided. Is there a way to manually uninstall REW? I tried the uninstall.exe in REW folder - no response from this file either.

I have been using REW for several years. Always updating to the latest release. I recently updated to Windows 11 and I can not launch/uninstall REW. There is no error message - just no response. REW does not show up in Windows/Settings/Apps/Installed Apps. I realize this is probably a Windows...

I'm located near Denver

jtalden and Jm - thanks for you responses. I do have a minidsp 2x4 - The measurements were not level calibrated. I do have a question about this however. The mic cal file I am using does have a microphone sensitivity figure that is not used. I have enclosed the cal file - there may be a file...

I would like some help analyzing measurements of my audio system. I have enclosed the measurements at the LP for: - Front SW only (Polk PSW 125) - Rear SW only (Polk PSW 125) - Front left main (Kitty Kat Revelator) - Front Left main (Kitty Kat Revelator) Sony STR-DG1000 Home theater receiver...

It's difficult to speculate without knowing the difference physically or electrically between the two sets of measurements

You can compute an arithmetic average in the All SPL window - there is a button on the lower left of the graph "Averages the Responses" - it will arithmetically average all responses that are checked.

Vector averaging uses both magnitude and phase.

Yeah - I currently have r/w permissions for the share (not full control). My reason for mentioning this problem is that in prior REW versions file saving worked and now it does't unless REW is ran as admin. I understand you believe this is OS related and I can always run REW as admin. My intent...

I am not sure when this changed but now I am not able to save measurements to a network share due to permission unless I run REW as administrator. Beta 41, Any insight?

Thank you for your prompt reply and resolution.

The original measurement is selected but grayed out . I'm I missing something? in EQ window after Beta 40

I searched but could not find the answer. I apologize if this has already been answered.

Reflective wall materials 125 Hz 250 Hz 500 Hz 1 kHz 2 kHz 4 kHz Plasterboard (12mm (1/2″) paneling on studs) 0.29 0.1 0.06 0.05 0.04 0.04 Plaster (gypsum or lime, on masonry) 0.01 0.02 0.02 0.03 0.04 0.05 Plaster (gypsum or lime, on wood lath) 0.14 0.1 0.06 0.05 0.04 0.04