Sixto

Took a while, after several calls to product support (these guys were great) but we finally came to the conclusion that my USB interface...

I use a UMIK-1 plugged direct into my laptop. look on HIFiShark.com if you can find a used UMIK-1 at a good price. It's literally plug...

I looked at your last mdat file and applied the time gating. your first reflections are very close at only 1.33ms which is less that two...

" Is it better to measure and equalize based on quasi-anechoic conditions?" It is crucial. Your ear/brain notices the freq response...

Make 4 channels out of the 2 stereo ones. Add to the individual channels, resources that really belong to them; X-over and driver...

You are correct. I can EQ the four analog outputs using my two step method. I can then do a full range sweep and do a final EQ on the...

What I do is run them separately to get the levels matched, and then run both at the same time and input the PEQs in the appropriate...

The 'two step' method at the crosser point seems to work well. Regards, Dan

Thanks! I will keep my eye out for a deal Steve, thanks for taking the time to provide such a thoughtful response. While I wait to...

Do you really need to separate the filters for the LP and HP? Why not generate one filter file and import it into all 4 MiniDSP...

While I wait for an answer from Focusrite (repair the broken unit or buy new) I figured I'd go ahead and re-measure the individual...

Its the USB Interface that's the cause of the odd SPL measurements. Tried a different amp - no difference. Tried a different interface...

I don't know where the problem is, but there's clearly something strange going-on with my REW Measurement setup...

I agree, I’m just looking to get wide baseline measurements (to whatever accuracy I get) that I can trim-off later with a high-pass...

I would not use psychoacoustic smoothing as it will give you an inaccurate impression. Apparently 1/3rd octave is industry standard so...