-
-
Ppaul8 replied to the thread REW subwoofer delay measurements don't make sense.Yes, for those measurement for L and R sub was enabled, but since timing signal is limited in frequency and not going through sub anyway...
-
Ppaul8 replied to the thread REW subwoofer delay measurements don't make sense.I tried alignment tool with both phase and impulse, they show approximately same value, which is hard to make sense of. The mdat is...
-
Ppaul8 replied to the thread REW subwoofer delay measurements don't make sense.Which different electrical paths? REW shows near 0 delay in its IR delay measurement, yet 4ft in its alignment tool using same IR data...
-
Ppaul8 replied to the thread REW subwoofer delay measurements don't make sense.I'm trying to measure a new subwoofer, if I align the sub by using delay value against an acoustic reference sound wise it actually...
-
Ppaul8 replied to the thread Newbie: phase adj of subwoofer using REW + Umik-1 (minidsp).Too bad this approach does not match Audyssey results, neither it provides any audible difference.
-
Ppaul8 replied to the thread Loudspeaker step response looks unusual.Nothing special about my room, 300 sq ft, with cathedral ceilings, the speakers are against the longer wall, the mic is on the tripod on...
-
PThis isn't the same measurement I was referring to earlier since the step response here looks time-aligned, but it's alright. The same...
-
PIf you look at your "RT60" plot, you will see that your room is basically not damped at all, with reverberation times around 0.9...
-
Ppaul8 replied to the thread Loudspeaker step response looks unusual.OS itself has no business re-sending anything, my version of Linux uses ALSA sound system, which is normally transparent to...
-
Ppaul8 replied to the thread Loudspeaker step response looks unusual.Attaching mdat. I doubt that the crossover would cause this on brand new speakers.
-
Ppaul8 replied to the thread Loudspeaker step response looks unusual.It is just 1 speaker, I'm only sending L signal, no sub involved. I also have similar measurement for R speaker, looks identical. My...
-
Ppaul8 replied to the thread Loudspeaker step response looks unusual.This is step from another speaker of mine, looks more conventional to me:
-
-
Ppaul8 replied to the thread Loudspeaker step response looks unusual.I thought that second spike around 1.8 ms is from my sub, so I put my receiver into LFE only mode, and set the speaker crossover to...
-
-
Ppaul8 reacted to John Mulcahy's post in the thread REW subwoofer delay measurements don't make sense with
Like.
Delay measurements are unreliable for low bandwidth devices like subwoofers, the alignment tool is best for that.
-
-
Loading…
-
Loading…
