Recent content by narut titayangkurn

Do you mean I should measure the loudness of the sub-main integration with a regular sweep from 20-20000 Hz? Thank you

Thank you a lot for every one comment

Hi there During the weekend, I tried to match the subwoofer level with the main speakers with pink noise section in REW's generator. My mic is UMIK-1 I measured the main speakers with Speaker Cal Pink noise and subwoofer with Sub Cal pink noise. even though the SPL meter said loudness is the...

HI there. I searched the forum for the use of Impulse response to get optimal 2 ch speakers setup. All of them are about subwoofer. Is there a guideline available for a stereo system? Thank you very much.

EDT, T20, T30: Hi there, the measurement can give us the values of this RT time. My questions are - Is there any book that describes how human feel about this EDT, T20, T30 - If we are to optimize the room to have an optimal RT time which value should we focus on? - Is there a standard that...

Dear John. Thank you a lot for your help

Dear John I attached the .mdat file to the link below From time to time, I found missing RT Value in certain Hz but I have had no clue how to fix it. I tried - varying number of sweeps and file length combinations, - increasing the sound source making it around 90dB. - swapping between...

HI there. I have a question about the missing value in the 500Khz in the T20 and T30 graph. I tried to change a sound source location and mic positions. But the result of measurements was more or less the same. Some graph were missing 1kHz, some missing 800Hz. but the one show was missing 500 Hz...