Recent content by mikewellington

Hi Craig. Not exactly sure but perhaps you could monitor via a third party VST convolution plugin in Samplitude that would load the wav file and pass your audio via that in real time (if that is possible.....?) I've never used an exported convolution file from REW. Personally I use a hardware...

Hi Wayne. I made some new measurements with the Q2031B and captured the results (above) LEFT & RIGHT OFF, LEFT & RIGHT ON, LEFT ON & OFF, RIGHT ON & OFF This seems to be a better representation of what is actually going on. It would appear that my left hand side has more issues. Even though I...

Hi - I uploaded using the scale you suggested (see above). The only reason I changed was because the non graphic was so loud. I will make some more measurements without the graphic again, at a better volume this time and then they can be compared against the results achieved with the parametric...

Hey Wayne. Thanks very much for your input and the Yamaha YDP2006 tip. Searching now. Yeah I am going to return the Q2031B - I was hoping for much more. I will upload another graph using the scales you suggested. I am determined to finally make some progress!! Plus I hope this will help...

Thanks John. I was thinking about using a parametric instead with HPF to roll off the lows. I think I will try this next. Generally, how do you think my readings look for a studio environment? Anyone else? Your advice/input would be greatly appreciated. Thanks.

Hi. I have been trying to improve my home studio acoustics. I've been using REW on and off for about two years and have a reasonable understanding of how to take measurements and interpret them. Here I am using a UMIK-1 and my studio audio interface applying 1/12 smoothing to the measurements...

It's all coming back to me now. Made a couple of measurements 45 Hz-20,000 Hz with 1/6 smoothing. Looking good. Is there a place to post measurements on here to get feedback?

Thanks John. I had tried that and also a reboot. Seems to have done the trick. It's been a while since I used REW and my UMIK-1. Just moved into a new studio so trying to get my head back into the software again. Is there a link on tis website to the basic read out settings - I remember being...

Hi - I am pretty sure I have everything connected okay. I am using the UMK-1 and a USB audio interface that is connected to my speakers. I have the UMIK-1 set as the input device loaded with its calibration file. I have the audio interface outputting a decent level to the speakers but I keep...