Hello, I took amok measurement, I would appreciate it if you could guide me through generation of EQ.
My gears are as follows:
- Speakers: KEF LS50 Original
- Sub: SVS Micro 1000 (with Param EQ)
- Pre-amp/DAC for EQ: RME ADI-2
My setup: Streamer-> RME DAC/EQ ->AMP (NAD C209) -> L&R output...
I don't see the +SUB option. I use RME-ADI2 as my preamp and this is what I connected to REW (only L &R output to my amp).
Anyways, I made a measurement (with my SUB on at a balanced level - how I usually listen to my music). Please see the result as attached. I am very confused about how to...
Hi, I’m a newbie to REW. I have some confusion about sub measurement as follows:
- When I perform the measurement of L+R should I keep my sub on or off?
- if I should keep it on, what should I set the sub volume and crossover to?
- If I should turn off the sub and measure it separately (with...
Hey thanks for getting back to me.
I read your post. It somehow made sense to me. Even though, I still have some confusion on how to tailor the EQ generation based on RME capabilities. As you know, RME used to have 5 EQ lines, however, since then they added Base and Treble as EQ lines, so there...
Hi Folks. Newbie here. I have performed my first measurement with UMIK-1 and REW. I need your help to understand how to generate & translate my EQ measurements into RME parameters.
I could not find a way to generate EQ according to RME parameters and capabilities. I tried using Generic EQ with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.