Recent content by justbob

So it seems this error has something to do with attempting to use a Mid-Band correction in the Correction Procedure Designer. Once I removed that the filter generation would work again. Guess I wont attempt to use that feature going forward to avoid the headaches.

Hello Bernt, This error occurs not on start-up but after the program has been running fine for a few hours. It occurs at the time the Generate Correction Filter button is clicked. So I renamed the AL.ini file as suggested to give it a try. I setup all the configuration again now this time I...

Hello, Does anyone know the cause and fix for this obnoxious error message? It seems that once you get it the 1st time, there is no escape from it. Every time it occurs the steam starts coming out of my ears. Closing the program and reopening it doesn't fix it. It seems to be tied to a setting...

OK Bernt, thanks for the clarification on this

Hello Bernt, could you please be more specific on where you are seeing the bass offloading Freq being set to 250hz and where I should be entering 70hz instead? When I am looking at the speaker tab, the one in the screenshot I provided, I don't see the term "bass offloading" anywhere. I see...

Hello, Maybe someone can explain what I might be doing wrong here. I have a 2.1 speaker setup with 2 main monitors and 1 Sub. I am attempting to apply a High-Pass X-Over on the 2 main speakers so that they will start rolling off at 70hz. As far as I can tell the speaker setup Tabs are correct...

Hello John, I've been under the impression that someone should strive to use a timing reference (be it an acoustic one or lookback) whenever possible. For my purposes, I am intending to measure the Room and use the results to make decisions on tweaking correction filters and where to place...

Hello, back again. I was playing around with creating a Loopback within the Hilo last night and it appeared to be working as expected based on the measurement results once the sound card calibration completed. The results were ruler flat across the board which, according to the Help file, was a...

Thanks for the additional explanation and details

OK, so let me ask this. Based on your response about setting up a Local Loopback within the Lynx (I assume you mean using the routing matrix only to create a virtual Loopback?) Create a route within the internal matrix using USB Playback Channel 5 >>>> TO >>> USB Record Channel 5 and then...

OK I will be sure to keep this in mind when setting up the Lynx. I should have wrote these two questions in my last reply a bit differently in hopes they could be addressed. What would be the best way to handle the Loopback/Timing reference settings with a setup like mine? Am I correct that...

Hello Sir, thanks for the response. I will skip the sound card calibration process then. Good to hear. Can you clarify the quoted reply above though. Are you referring to the Loopback configuration section below? If so, should I just leave these two options not configured? So no Loopback and no...

Hello, So I'm trying to wrap my head around how to best configure REW while using a pair of active Genelec monitors in combination with a Lynx Hilo as the audio interface feeding the Genelec's. The Lynx Hilo I am using contains a USB Card and uses the Lynx ASIO driver for Windows (Windows 11...

Ok thanks for the reply. I'll keep my eye out for that in future releases. I think it will be a great addition to an already great piece of software :T

Hello, I have a few questions about the Polarity Correction option seen in the Measurement Tab. In the User guide .pdf it mentions that "All corrections in Audiolense are made such that all speakers and drivers have a positive polarity after correction." First a few questions on this specific...