Recent content by jjack87

Got the loopback levels to match. When I run the measurement for the audio interface though I get this reading which doesn't seem right.

Hi John, Thanks for the reply and notes - very helpful :) Figured out that I wasn't seeing ANY loopback signal - just ground noise - from when the line input is turned up that high. I had alternate monitors setup in the routing which was overriding my line outputs. Just fyi. Many many thanks!

Checked levels within UAD console and the monitor and and output reference levels already set to highest. Trying to configure within Audio midi setup, but not seeing the ability to adjust.

Thanks for the note. Changed to what you've said above. Any thoughts towards getting the output level to match input level? Still quite a big difference. Many thanks!!

Just running an apollo twin duo

Hi Guys, I’m following the “Improve the sound of your home studio – using room eq wizard series” but I’m having some difficulty calibrating my soundcard. The line level loopback connection is too low, even with the gain all the way up. Thought of adjusting the output volume, but that option is...

Worked out! See now where it wasn't quite setup correctly.. Thank you!!

Also, good to know about SPL. Thanks.

Sorry about that, thought I did. Updated :)

Hi guys, Wondering if I could get some help with this. Not getting the room measurement I was expecting (Also, first time using REW). Tried multiple times with same result. Outline Setup: Mac mini / Apollo twin / XREF 20 calibration mic Blue: Soundcard sweep Red: Measurement microphone sweep...