Recent content by gpershall

The xover was set to 250 as I was working with REW and the MiniDSP setting up my subwoofers. It is normally set at 80. I was just concerned that I was seeing sound output in the mains when running a 20-80 hz sweep with the xover at 250. It was probably due to my receiver being in the stereo...

Good point. Will try later not in stereo mode

1st try with running REW on my Marantz SR7013 system. System consists of Martin Logan motion 40's mains, Marti When Logan XT50 center and dual SVS SB13 Ultras. I set the XOVER to ALL 250 in the receiver, mode to stereo, mains to small. REW prefs were, JAVA, UMIK1. MiniDSP HD, When running...

Got this problem figured out. Was sure it was the laptop so returned to BESTBUY and got a new one.. WELL.... same problem. Got to thinking it has to be something in the software or config of the microphone's. Got to poking around and there is a setting under System, sound, input, then select...

Thanks for the suggestions. Will give this a try later today. Should the dips at 70hz be addressed?

!st time REW user, Marantz 7013, 2 SVS SB13 subs, Martin Logan XT40 LR mains, Martin Logan XT50 center, Martin Logan surround and Atmos in ceiling. Did a 1st run of REW and the results are less that good, IMHO. I have done no EQ or movement of the subs. Both subs have been upgraded to the new...

I am sure it is something in the new laptop as I have uninstalled REW on this laptop and my Surface Pro7, Reloaded REW on both and ran with the same configuration and the Surface works great.

This is the contents of the only log file that had data. Jun 07, 2021 4:43:50 PM roomeqwizard.RoomEQ_Wizard main INFO: REW V5.20 running JRE 1.8.0_202 64-bit on Windows 10, en, US, windows-1252 at 96 DPI Jun 07, 2021 4:43:51 PM roomeqwizard.RoomEQ_Wizard$5 run INFO: 11th Gen Intel(R) Core(TM)...

Yes I hear a loud test tone. the input vol was 0.53 my bad. Another strange thing is while playing a test tone and the SPL meter is reading 37DB I can talk into the mike and I see the SPL jump up to 70 to 80. Also I an a raw newby to REW .

Soundcard prefs. Java driver, output default device (laptop speakers), Input device UMIK1 positioned next to laptop speakers, control input vol checked , input vol .053 , everything else default. Clicking check levels . Output volume graph reads -12, in and ref in reads -93. SPL meter reads 37...

After further investigation it looks like there is something in my laptop (HP Spectre X360) that may be causing the issue. Connected the UMIK1 to my Surface Pro7 and ran REW and the SPL meter and sound performs ok. Thought I would try the REW SPL meter using the built in MIC on the HP and get...

windows 10 system running REW 5.20 with UMIK1. I cannot get any true SPL readings while playing test tones. The SPL meter reads the sound level of the room, in my case around 37DB. If I speak or play music in the room the SPL meter shows the increased volume of the room. Running basically...