Recent content by gorgig

Hey everyone, Thanks for the replies and help. I have implemented sonarworks and applied the B&K curve and taken away two of the bottom traps. I will see how the mixes translate. Cheers

I have attached a plan of the room, it is very irregular.... OK, I actually just put these in a few days ago.... and yes all traps are DIY. In regards to everything you circled... they are all new... I have attached a mix/production I done before they were installed. https...

This is a similar style... done professionally... https:// soundcloud.com/chrislake/chris-lake-walker-royce-dance-with-me which is in E, which is super low but I feel has a better balance and 'thump' than what I've sent through.. in regards to room treatment.... basically all bass traps...

there must be something with the forum posts... just type https:// before this... soundcloud.com/burekbrothers/dancewivu2/s-P5exL wow this is sounding ridiculous lol so sorry....

Wow, sorry not sure why avnirvana changes the link once I post? So sorry, try this link....

grr sorry this

Sorry not sure what is going on with these links... try this and thank you

Sorry try this link

Sorry try this link

Sorry to add again but it feels like the track is missing some high end? which in the production room sounds fine but translates without the high end?

Sorry here is the link

Hi pklose It's a production room for mainly EDM style music. I am not sure why there is a roll off for the HF, I posted a calibration for my soundcard, RME Fireface 800 and another user mentioned this and asked if I had an EQ on the mix but no there is nothing so I am not sure what this is...

Hey everyone, I've attached my .mdat file from REW and wanted some assistance with interpreting the data and any recommendations on room treatment? Any help will be appreciated, Thanks

Hey John, I saw that when I done the calibration for the soundcard, nothing active in regards to EQ... not sure why that has occurred. I might try to do the calibration again and re-do the measurement. Thanks for that

Hey everyone, I just setup REW using a Dayton EMM-6 mic and have attached the graph and .mdat file. Can somebody please assist in helping to understand this and if the actual measurement was done correctly? Thanks!