Recent content by Earfonia

I'm not an expert but theoretically I think is should be ok to use parallel resistors for Rsense

Yes, I calibrated the measurement using multiple resistor reference: 600-ohm, 300-ohm, 32-ohm, 16-ohm, and 3-ohm. Impedance measurement for all those resistors are accurate. Oh yeas this works, thank you!

I tried that, still clipped at 1000 ohm cannot display more than 1000 ohm. Thank you!

Hi! I would like to request some improvement on Impedance display. With V5.20.4 the maximum impedance value that can be displayed is 1000 ohms. I recently measured Beyerdynamic T1 1st Gen impedance, and it peaks at around 1480 ohms. The peak clipped on the display due to the 1000 ohms maximum...

Thank you!

Ok I found the fix, I have to check the 'Normalize data to fundamental':

Hi! I would like to get some help with REW Export distortion data as text. I've read the help section of REW for the Export distortion data as text. But in my case I got weird numbers in the THD (%) column. The value in the THD (%) column in the exported text file is totally different from the...