Recent content by Benny-R

What a relief! Thank you so much again for your help.

Hey there, I took some measurements in a venue I work in recently and am having trouble understanding the EDT times, as some of them seem to be longer than the T20. I've been referring to ISO 3382 and am not entirely sure if I understand the EDT measurement properly. Is the EDT time extrapolated...

That's really great of you! what a legend!

This clarifies things somewhat. Many thanks :)

Hi there I'm measuring the acoustics in a music venue and have taken 11 sweeps in different positions around the room. I was hoping to be able to average the results for these in addition to looking at them individually. This works fine for Frequency Response, but when I do DB + Phase, or RMS +...

That's great, I'll see if I can get in there again to try this. Otherwise I guess I can just subtract the stated delay time from the values on the plot. Thanks so much for your help

See here my souncard setup. Many thanks

Hi there. I was using UA VOLT2 interface with an earthworks measurement mic. I see now from the measurement dialogue that there it describes a delay. I didn't use a timing reference. I'm waiting on earthworks cal data, so hence no cal file, not that this should affect the subject in question...

Also apologies for incorrect thread title. Should read: Spectrogram Offset

Hi everyone First post here, so please be gentle. I recently used REW to measure a venue I work in using a sine sweep. I've attached the spectrogram of the reading taken at the mix position, which seems to seems to show she sweep arriving at around ~2.55s. I'm not sure why this is as this...