aps

Yes, that’s my experience - the problem was introduced with Roon 2.0 Build 1272. I’ve raised a support call as well as a thread in the...

I misread your post. I thought you were saying there is a convolver version 1.8 now. I turns out you were talking about Roon 1.8 !! So...

Gain management matters and not always easy to balance the competing requirements. In my system, I ended up wiring a simple "vintage"...

Well, no response to date on the Roon Support forum but back on with music using the in-built Roon convolution. Interestingly, there...

I recommend that you try the Roon support unless someone gives you the right answer here.

I've uninstalled and reinstalled both Roon and AL Convolver but the problem remains. Also, attempted a fix that I saw on the Roon forum...

I believe Roon sometimes ignores a device after instances where Roon and the device aren't operating properly. . I reinstalled Roon when...

Bernt I've been tinkering with measurements and gain control but run into a problem. The problem is that AL Convolver is no longer able...

Much appreciated. Yes, the RME has three gain settings and I've got the unit set to the lowest setting (-10dBV). I'll set a limit of...

This relates to sound quality as well as convenience. In Al convolver you can set up the volume control to max at -20 dB or whatever you...

Most likely not. The best is usually to turn off Al dsp … and if impossible …. Set the sub low pass filter on the highest possible value.

I’m using Roon as a front end that sends audio to Audiolense Convolver which executes filters for 3-way active speakers. These...

I’m using Audiolense to build filters for a (DIY) active speaker setup that includes one active sub. The sub has on-board parametric EQ...