Recent content by 2206

Hi there! Hi made the measurement shown below using the wavelet. The vertical traces show (moderate) room mode ringing (delay). But what are the horizontal "wiggles"? Reflection should be straight lines, or? You knows more about wavelets? Many thanks!

Note: Signals from and to REW go through left and right, which is Analog 1 and Analog 2 (output or input). Open Audio Midi Setup (Utilities, Application), click Configure Speaker. Calibration: Chose Analog 1 and 2 for left and right output signals. Signals from REW will go to Playback Channel...

I was wondering about averaging as well. Apparently, "average" is not simply the arithmetic average nor is it the dB average if I look at the attached graph (green: two measurements, purple: average). In fact, it would be helpful to see the average as well as the standard or maximum deviation in...

REW 5.19 beta 8 works now on my MAC! Very excellent! I noticed that after restart I have to reset sample rate to 96kHz, not a big deal but probably easy to fix. Great Job! Cheers

Wow, that did it! SPL is the same in SPL and distortion window. Noise floor is at around 22dB and climbs to 50dB at the low end. RTA is similar, a little lower. Thanks a lot. Cheers!

I have seen this for several days now, that is after power down and restart. As I could not make sense of it, I thought I'd check with the experts. I am new to REW. I am using REW V5.19 Beta 8 on Mac.

I am on a Mac...

Can't find the pref. file? Is there a uninstall app for REW? Thanks!

Voila SPL and distortion window SPL window gives about 90dB. Distortion window is more like 70dB for the fundamental. Distortion (dB SPL) is at around 30-40dB or about 30-40dB below the fundamental. How is the fundamental defined? Apparently adding 30-40dB of distortion to 70dB fundamental...

I noticed that the SPL level in the SPL window and in the Distortion window are not alike. The SPL window shows higher dB values - 10dB or more - than the fundamental in the Distortion window. What is going on? Thanks in advance!

With the UFX or a similar multichannel interface REW only knows L and R as inputs and outputs. So, in the Audio/MIDI application under Configure Speakers choose Analog 1 and Analog 2 as output (software playback). Sound from REW will be routed now to these channels, which in TotalMix can be...