-
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.FSAF file length is 35 MB. The delay appears with all three tabs with which REW was closed. But on the SPL and Impedance tab there is no...
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.This only happens the first time after running REW. All subsequent openings of the slowdown window are not present. Should I take...
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.There was once an issue that the measurement window took a long time to load due to the FSAF setting, even if the FSAF tab was not used...
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.The level in the Measure window and in the Preferences window was -9.7. I installed them before calibration. Just in case, there is a video.
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.John, after the second impedance calibration step, the level value becomes -3.01 dB. Although before that I set -9.7 dB in the...
-
Ssm52 replied to the thread Advise to interpret REW measurements.I thought the same thing. Listen carefully when the sweep sounds. If you specified in REW that the sweep should be from one channel, for...
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.In beta 113, the display is correct in this place. But elsewhere it is wrong (In beta 118, the display is correct in this place.).
-
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.Wrong in both cases, with EXCL and without EXCL.
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.The output level for Java and ASIO was different for me before when I had Windows 7. The difference was 0.06 dB. On Windows 10 this is...
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.
-
-
Ssm52 replied to the thread REW Beta Release REW API beta releases.John, hi. I measure impedances. Before calibration, I check the levels in the Preferences, Soundcard window. There are 4 cases where the...
-
-
Ssm52 replied to the thread Cannot Calibrate REW with UMIK-2.The phone cannot be used for precise measurements. Even if you calibrate the phone at one SPL value, at another SPL value it will lie...
-
SYou're right, to the left side of this picture is a open floor plan with dining and kitchen area. Sub to the left may be possible, if...
-
Ssm52 replied to the thread Help wanted in integrating sub using delay.Yes, the subwoofer level needs to be lowered relative to the measurements from post #10 by 6 dB. It should look like the picture. One...
-
-
-
Loading…
-
Loading…
