Hi John,
Thanks for the help
I have tested the voltage with a signal at 1khz as it is some sort of standard I have read, I have now tried with a sine-wave of 50Hz (as the grid in europe) and it seem stable but something still isn't right or I don't understand the concept.
Am I wrong to...
Hi,
Thanks for responding
No fortunately It is not that bad as you imagine, so allow me to detail a bit more
It's between each test session that I'd like to get back to the same levels, but also have the habit to lower the gain level to 0 on the amplifier and the main before on the audio...
Hi Guys,
Before everything else I have to announce that I am a beginner in REW but also in the concept of acoustic measurements, I have the following equipment :
Behringer UMC204HD
Dayton AudioEMM-6
T.Amp PM40C amplifier
And all the cables in between including the loopback
I have made some...
Hi Dan,
I have a UMC204HD and have started doing some measurements with REW also, I had an issue like you but found it was better by setting the "Phones" rotary knob level to 0 before any measurements.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.