Recent content by Wull

Thanks John. I did know that, just wasn't sure how to set it to 320u/2.0ms. Think I'm OK with the settings I have.

Hi John. How do I set impulse to this scale (2.00ms)?

Thanks John

results below.

Been running some sweeps and I get the feeling my centre speaker could be out of phase. What would be the best way to check this please?

Thank you so much. 'Sealed subs. 2' appears to give me the better result, and is the one I will stick with. I have run my processor EQ. With this enabled the L & R channels combined produce a nasty null around 70-80Hz. however your delay really helps with this (not so much with sealed subs).

Hi jtalden. Would you mind having a look at my latest REW measurements to see what XO would suit please. These are a fresh set of MSO results. Instead of combining my 'front of room IB manifold' with 'rear of room IB manifold' & '2 x DIY ported subs' (this equates to 4 subs), I sealed the ports...

I hope I've done this correctly. 80Hz XO I added a further 6.54ms delay (I cannot reduce the sub delay so I increased the mains speakers) The left speaker is now 39.04ms and the right speaker 40.06ms. Attached results

My setup is pretty much the same. The only things changed are I’ve added a further minidsp HD, also taken measurements from a MLP that provide a better LFE. I’ve used MSO to optimize my subs this time, this is probably why there is a large XO range.

Cheers jtalden. Attached are the results using your SW delays provided. Looks promising. I intend to run my processors EQ at the weekend (it does not provide speaker distances) this may help the final result? I shall report back.

New measurements taken.

The measurements taken are not central to the mains. Decided on a different approach this time. My couch is central to the room but where I sit is to one side (the right).. This position also give me the best bass response. The Mic is still in place from these measurements. I will adjust the...

Hi. Would anyone be kind enough to look at my REW sweeps to determine what delay I should use to align my front speakers with my sub response. Both are presently set to 0

I set all levels to the Dirac set up guide I have. L,C,R,LBS,RBS = 85dB. LS,RS = 82dB. LFE = 91dB. I agree. I need to start listening to the results and take it from there :T

option 1 & 2 Dirac results. I've also attached the Dirac before & after plot. Seem to be loosing a lot of output 25Hz-40Hz?