Recent content by vadimal12

hello! Tell me how to install V5.30 on windows 10? Using the link, I downloaded a file with the extension (.sh). I run it from the communal drain and .. nothing is happening

Behringer UMC202HD. thanks, everything is already working as it should.

I have everything in order with the measurements of the USB microphone. Problems when measuring with a wired NON-USB microphone.

Yes, I use Dayton Audio UMM-6 USB

Please explain your question in more detail.

Thank you very much for your support. I'll go figure it out.

Yes, I have installed it, I take the feedback signal from the speaker terminals

The loopback gets the same sweep signal as the measurement channel - yes. but after all, when measuring "use acoustic timing reference" everything works correctly. When measuring "use loopback as timing reference", I do not make any changes to the switching (and I do not change anything from the...

Yes, because when I measure acoustically, a master pulse goes to channel L

Да, потому что, когда я измеряю акустически, главный импульс поступает на канал L

It used to work for me too ))).

Hello! version 5.20.14. - previously everything worked fine. But, it is not clear for what reason I cannot measure now with "use loopback as timing reference". There is no "ref output" master pulse. Moreover, in the "use loopback as timing reference" mode, everything works fine.

Thank you. Everything is fine. I figured it out.

I asked a fellow forum member to follow my example. He succeeded.

Hello! I create a file, load it into the program and see a non-linear phase. I tried different versions, it turned out to be an almost even phase in version 5.19. How to get an even phase in a file?