Recent content by rphud

Thanks. I have been playing with the PC and miniDSP settings and getting some things to work and others not so much. I have been able to get the REW working though. I am still wrestling with how to get the PC to output to multiple places as well. Most things I see online are not working...

I was able to get it to work by using the analog output to the miniDSP. I would like to use the optical output if possible though.

Tried EXCL: Speakers (3- miniDSP 2x4n) as well.

Just tried setting everything to Speakers (3- miniDSP 2x4n) and I still cannot generate a check levels output.

I am using the optical output from the Sound Blaster Audigy 5/Rx to the miniDSP right now. If that will not work I can change it.

I switched over to using a Sound Blaster Audigy 5/Rx card for sound outputs and am using miniDSP as well. I can play music from my PC but I cannot seem to generate a sound card test signal again. It looks like the proper output device is selected, but there are two and tried both SPDIF OUT and...

Got it. Does go for the sound card calibration as well? That being said, I am trying to see if I can "smooth out" the response graphs I am getting in the end.

That worked. Next thing is how to loop things for calibration. Using the speaker output on the back of my PC, but not sure where that would be plugged into. Maybe the microphone jack right next to it. I am using a USB microphone if that makes a difference.

Did not click on next, clicked on check levels and it seemed to start. I will try that, thanks!

Current sweep recordings look pretty jittery/jagged and I am assuming the calibration might clear that up a bit.

There does not appear to be any sweep signal output when I attempt calibration. There are outputs when I take measurements but not calibration. Thanks for the help on this Bob H