Recent content by redmountain

ok sorry Thank you I'll stick with what I have for now Best Klaus

I just followed your advice ( thus the quote ) for stepped sine measurement to be better used for distortion... As for v5.40... I am running a MBP9,1 with Macos 10.13 / 10.14 and now you want a higher Macos to work with REW ? Please make it work on 10.14.6 since I specially upgraded to 10.14.6...

How should I interpret the distortion figures in these measurements - also stepped sine... The Motu 896mk3hd was measured with a loopback @ 48, 96 and 192 kHz Distortion figures in stepped sine measurements go way up in the highs...with higher sampling rates Thanks for hints Klaus

Motu is the clock master as I said all fine now pic : ( please report if I still am to dense )

I didn't find them searching this forum... Thanks for confirming !

Thank you For real world results I use Smaart...until now Maybe REW does that too ? ( from XLR out to XLR in ? )

and now it seems to work with all the widgets, former user account...

64k in and out

Hmmhh... If I start the generator and start RTA after, the clock ∆ goes down to ca. 1.8 ppm and then struggles If I start RTA first then the generator, the clock ∆ goes down all the way to 0.2 ppm and no flickering... Is this only on my rig ?

How can we find out ?

Soundpath : Motu analog out 1+2 out ( defined as output channel mapping 3+4 in REW ) Motu analog in 5+6 as input timing ref analog out 2 loopback input analog 6 wrong ?

...if such dropouts happen, I would hear them for sure, not ? I can listen to the loopback and can't hear anything... I can re-check but am alsmost sure the clocks are the same everywhere...

> new account nothing in the menu bar no login items > still clock ∆ ? Macos / coreaudio ?

Buffer(s) ?

Sorry > edit post > re 48khz