Recent content by rajdude

Hi John, I found out what the problem is! :cool: Basically it is my XLR mic's USB preamp which is probably incompatible with ASIO4ALL More details here...

Thanks John..... I am at my wits end over this. One thing I can say.....it has got to be some hardware issue......because I have used two different laptops already. The only common thing is the hardware. Maybe ASIO does not work well with my Emotiva XMC-1 Or it could be the HDMI cable from my...

Thanks Just checked that also. Both in and out devices are set to 16 bit 48 KHz if running in shared mode. Then tested it again...........same distortion is present. Any other tips? Is there a different ASIO driver I should try out? Would this be a HDMI cable problem? PS: I do not think...

I found some info in the logs...........does this help troubleshoot................? Jul 14, 2021 6:17:09 PM roomeqwizard.RoomEQ_Wizard main INFO: REW V5.20 running JRE 1.8.0_202 64-bit on Windows 10, en, US, windows-1252 at 96 DPI Jul 14, 2021 6:17:12 PM roomeqwizard.RoomEQ_Wizard$5 run INFO...

Another day.........back to troubleshooting REW <> ASIO :-( It is very interesting to see that there is literally only one other mention of this error on the ENTIRE internet! LoL When I google this error only one page shows up...

uh oh......... When I hit check levels....... REW says "unable to start ASIO capture"

I just downloaded and installed the latest beta version of REW...........same behaviour :-( WOAH!!!!!! I now see that little control panel.......... when I switch to flex asio.............trying it out.........

Thanks for helping me John. I do not think the control panel for FlexASIO has even been written/implemented. Clicking on the "ASIO control panel" button inside REW opens a web browser page and takes me to: FlexASIO/CONFIGURATION.md at flexasio-1.7a · dechamps/FlexASIO · GitHub It says this...

thanks John........I have implemented all the solutions you proposed one by one........sometimes it helps.........and other times it does nothing. Even if the problem gets resolved..........the noise comes back after running a few sweeps. The most improvement I got was by setting the USB-XLR...

I set it to max...no improvement! Then I even setup rew on a different laptop...with the latest asio. ...buffer turned up to full. It also has loud glitches (but different sounding) in the generator... rendering me unable to run a sweep. What else I could try?

oh Hi John! Thanks for creating this super-duper software! :cool: I do not have it in front of me right now (can check later) but I think I set that buffer to 700 something. I was running the stable version of ASIO4all. After the problem came back, I installed the latest, beta version of...

yes this is perfectly normal. When any application uses ASIO, Windows gives full control to that application.......removing sound card access to that application. The only way to get that application to play music or something else is to exit out that application (although I have seen that...

Thank you for that suggestion. I tried it and yes it does remove the noise. However, the noise comes back quickly after a couple of sweeps. I have also noticed that the noise gets removed on the preferences page............but when not on the measurement page. Any other suggestions? -Raj

Hello everyone, My first post here, so please be gentle ;-) I am coming back to REW after about a decade of non-use....so I do have a tiny bit of super old experience with REW. The problem I am facing is that while doing the setup tests and also during sweeps, I hear a recurring scratching...