Hey guys,
is there any way to export reverberation times below 50 Hz? Even through some "hacking" maybe? Yes i know about room acoustics and signal processing theory, that one must put a big questionmark behind these results... But is there a way?
Best
Johannes
Oh, that's to easy, sorry that I didn't check! Thank you so much already. But do you know, if I need to provide the truncate setting before measurement, if can I also do it after measurement, because maybe REW stored the whole thing somewhere?
Hey guys,
i wanted to measure reverberation time in a reverberation chamber with an expected rev. times from 10 sec to 2 sec frequency dependent. REW only got "good" RT60 data when I used 128k sweeps, a few times averaged (44,1kHz, 1 sweep was ca. 3 sec). Every other setting hat one or many 0...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.