Recent content by Naio

I guess my mistake was not to have figured out from the beginning that my mic inputs can also be used as line jacks and mic1 and mic 2 are the first two numerical inputs of the UCX and those are the ones that REW looks for. Once again, thanks for bearing with me here and your professional help...

Hi John....stupid me...I started measuring and only then found out that REW can only read a signal from the mic when connected to my mic 2 input (XLR Line combo input). I then used that mic2 input as the line input for the calibration with a TRS/Line cable and voila, it worked.... Thanks again...

I don't have any input signal problems with my DAW or with the UCX mixer, they see them and work, its just with the input signal on REW when calibrating, mic inputs work and all my line inputs as well with equipment connected.

Hi John, firs of all I want to thank you for taking the time to help me and go though all the details, I really appreciate your help and want to say thank you! AN1 and AN2 are two of my hardware Outputs on the UXC they are not inputs. If I run the signal generator in REW I do hear the output...

Under Configure Speakers it does not allow for much other than assigning the Analog 1-8 to the speakers, nothing on caning the input channels. The REW channel selection still shows the same options, see screen shots on output and input selections. I have attached the debit file. Hopefully that...

OK got it, I have selected the UCX as the input and output device for all my 8 analog inputs/outputs. Problem now is that the volume sliders are inactive..I have pulled up all faders of the SW Mixer from the UCX to make sure nothing is off...but still, cannot move the volume sliders in the...

I guess you refer to the Audio MIDI set up of the Fireface, I can see the UCX there with port 1 and 2 to be selected as an input/output, respectively. See screenshot....What I don't get it why there is a connection between MIDI when we route audio...

BTW I should mentioned that the calibration work when I use the internal AU engine from my Mac Pro and even the Display Audio of the Cinema display.

Hi John, I am totally lost...normally I figure audio/routing stuff out but this time I have to clue. I did check all the option the RME Firefcae Mixer SW gives me but I can't get it done. Can can you please elaborate on the Java Part....where can I find those settings as I am not familiar with...

Makes sense, I will try to figure that out

Hi John, Thanks for your reply. As the input AND output device I have selected my UCX Fireface interface. See attached screenshot. The second screenshot shows my UCX Software mixer GUI when I can see that I have an input and output signal, bit again no input on the REW calibration.

I am on OSX 10... with an RME UCX Fireface audio interface. The problem is in the calibration set up that I so not get an input signal in the calibration set up of REW when setting up an output/input loop via a cable on one channel (right channel). I do hear the test tone and I do see the...