Recent content by lbstyling

The sofa is indeed the MLP. I agree 2 feet closer listening position would be an excellent idea. I could do this on a occasional basis, however the sofa cannot live closer as we would have to walk around it on a daily basis. I have optimised the sub locations as best I can, however the one...

Three subs are located around the room. 1 behind second sofa, 1 built into kitchen cabinet and one at the far end of dining room. The third one is further away than audessey can allow in the software for delay (9m) . So I'm not sure how well audessey/A1 copes with this.

Hi, I have updated the first post to include subs. I have a location with space for more subs, so this is an option, but I don't know if I really need it. A1 seams to set the subs very light. I have done previous calibrations with MEQX that had sufficient slam, so it should be capable. I also...

Hi All, System is as follows:7.3.4 KEF speakers Denon X4800h MiniDSP/MSO being used. 2x AE TD15x subs + 1 x JBL 18" 2242H Behringer NU3000 (x2) for sub amps Room: 81m2 Photos: https://drive.google.com/file/d/11FFb_ZvZdf4pfaU4E76ZVYQ4uJbeskvc/view?usp=sharing...

Thanks John. I am going to run several sweeps and tests to check I have not done anything too silly, before I start really digging into this in detail. (need the weather to pick up so I can run some tests outside!):T

Hello, I was just planning to time align the drivers in my speaker when I set the Wavelet analysis up..... This is a 2 way horn with a LR 12db/oct crossover set at 800hz. Its a 350hz horn speaker, so does this mean there is a reflection at 15m/s (15 feet or so?) that needs to be removed ?

Found it! Also: I manually typed the filters in to the Hypex Fusion in the end.

Hello, This is a sweep of my JBl 2452H compression driver attached to a JMLC 350hz horn with a 3D printed throat connector to match the driver exit and horn entrance angle. Measurement was done at 5cm from the mouth. Questions: 1) I take it the phase moving all over the place is a result of...

I am currently making a filter in REW for a speaker driver to use in a Hypex fusion DSP amplifier. They Hypex has a max of 14 filters available left for me to use. What Equaliser option should I use for this device? It can only do IIR filters. I have tried the 'Generic' option, but this doesn't...