Recent content by lange.benjamin

Got it, learning each step of the way. I've included an mdat. I expect the DUT to have a low pass filter applied, so rubbish at the high end is about right. What else are these curves telling us? Thx, Ben

Ok, I've got the Pro Upgrade now. I'm attempting to compare the behavior of my reference microphone to a DUT microphone. I have a calibration file for the measurement microphone but not the DUT. Is that needed? How do I create that? I performed a multi-channel measurement and their a long...

Ok, I got my first measurement. Thx for pointing me in the right direction. Next step(s) Compare my measurement microphone and signal to a DUT microphone. Do I need to register REW to enable multi-channel recording?

I had a good conversation with my audio interface vendor. The details are above in my first post in this thread. I need a few tweaks on that side but more importantly I needed to get REW's setting configured correctly. The Timing Reference Output and Loopback Input needed to match the...

Starting from the bottom knowledge rung here, I'm not sure what "Disable all input monitoring" means. 1. I've turned the monitor gain dial to 0. It didn't really clean up the window. 2. I found an option within the FocusRite software to create a virtual loopback. That didn't seem to make a...

Fair point, getting the ports straight helps. There's a lot of things that can be misconfigured at the Scarlet layer. But this doesn't look that much better.

System: Windows 10 REW 5.20.13 FocusRite Scarlet 4i4 Loopback cable SS-BPBQMX2 - 2 FT TRS-XLRM Cale Sound Card Calibration: I'm following the tutorial videos to get started. Instructions say to connect a loop back cable so I connect the XLR port on the front to a TRS output port on the back...