Sorry , but post-43 measurements are without delay and no xo ( delays setting in the DSP are all to 0 ms) .
In post-41 it's the same same measurements ( delay setup = 0 ms) but xo are on.
Sorry, but I can't follow your reasoning, I'm lost.:frown:
What do you mean by this ? :ponder:
Ultimately , I think i will keep my current delays even if the phase curve is not as good as yours because i am not able to reproduce your reasoning.
Sorry, thank you again for your help.
Hello,
Thank you very much for your detailed and very informative response for me.
Yes, REW measurements have been made with FIR EQ ON.
I didn't try to make REW alignment with FIR EQ OFF.
So , you will find attached file with FIR EQ off , the sweep measurement is only limited by REW...
Hello,
In the Alignment tool , i can open a "Show phase trace window" (see attached picture).
Which are the phase curves displayed ? ( i suppose that are loudspeaker phase , minimum phase , and excess phase) : green curve , black curve , purple curve ?
Br
jacky
Hello,
If the usage of REW is more familiar for me now , thanks to you , but your experience is needed to solve the following problem :
- delay between sub and bass is 2.46ms , i must delay bass loudspeaker of this value.
- delay between bass and medium is 1.84 ms , i must also delay bass...
Some more questions :
- what is AT process (#27) => Alignment Tool?
- in the Alignment Tool , when i have a negative delay proposal , what is the meaning ?
For exemple , in the #27 post, your calculation give a delay of 3.21 ms on the 1-ms-bm-110-375 speaker (Low medium), so i can setup...
Thank you very mutch for this explanation.
With IR Window option , i can obtain the same result on the SPL and phase curves than the "Add frequency dependent window" when i reduce the "Left window (ms)" and "Right Window(ms)" values.
Could you give me some explanations or a link to understand...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.