Recent content by Jiffster

Thanks John, appreciate the support.

Got some more advice from the tech at Audient and I think it came out great!

OK, will do this evening. Thanks.

I reached out to support for my interface and it's software mixer and received some sound (no pun intended) advice that I think has me headed in the right direction. However, I'm not sure if the measurement I'm getting for the calibration is good enough. I know the calibration is supposed to...

When I attempt to calibrate my soundcard, I cannot get the level high enough unless I increase the level of my monitor. In doing so, I'm creating a feedback loop. Not sure how anyone can achieve -12dB without doing this. I cannot figure out what I am doing wrong. Have my output going into input...

There was no mic connected and I was sending the signal from othe output back to an input as stated in the calibration instructions.

During the "Soundcard Calibration" process, I need to adjust my monitor input level to get the input signal level near -12dB. In doing so, I seem to be creating a feedback loop. I have monitoring engaged and am feeding back into the inputs and I am not sure what to do to correct this and still...

When I have my interface monitoring set to mono, I get better results. Not sure if this should be done though.

Well I finally got an input signal at 48k but the measuring results may not look to good. Not sure how to correct this.

I am unable to get an input signal if my sample rate is set to 48, when calibrating my soundcard. I do when it is set to 44.1. My interface and all other audio setups are set to 48. Not sure what to do.