hulkss's latest activity
-
HHi Bernt, It would be great if there was a way to save the settings associated with a filter. We could then go back to an old filter...
-
Hhulkss replied to the thread Centre channel via Audiolense??.As you say, the center speaker is key. Three M2's is in no way a problem other than cost. I place my full size center speaker behind an...
-
Hhulkss replied to the thread Centre channel via Audiolense??.I use a center channel loudspeaker for multi-channel concert videos and up-mixed two channel music. In this application, I have achieved...
-
Hhulkss replied to the thread DTS Neural Surround UpMix plug-in with Audiolense.I prefer DTS. Halo UpMix works well too and has more adjustability. A lot of concert recordings have lame 5.1 audio and it is better to...
-
Hhulkss replied to the thread DTS Neural Surround UpMix plug-in with Audiolense.I verified the output channels from DTS Neural Upmix. Sure enough, it was sounding bad because I had the channels routed improperly...
-
Hhulkss replied to the thread 2 Channels in a 7.1 Container in Jriver.The Jriver output format needs to be set to the number of channels (or more) than you measured in Audiolense.
-
Hhulkss replied to the thread Earthworks M23R Cal file not accepted.Here's a sample mic cal file to use for formatting. Use a .cal filename extension for Audiolense
-
Hhulkss replied to the thread DTS Neural Surround UpMix plug-in with Audiolense.It's possible I was having a similar problem and did not verify the channels on my Mac Mini. I switched to Halo UpMix because DTS was...
-
Hhulkss replied to the thread DTS Neural Surround UpMix plug-in with Audiolense.You are only using two channels of the upmix output? DTS upmix has normal channel routing on my system. You can verify the outputs by...
-
Hhulkss replied to the thread DTS Neural Surround UpMix plug-in with Audiolense.I don't understand your output connection to the UpMix block?
-
Hhulkss replied to the thread Several questions before making the switch.Charbug and I calibrated his stereo system with Audiolense XO yesterday. I bet it sounds fantastic (I was participating remotely). The...
-
Hhulkss replied to the thread DTS Neural Surround UpMix plug-in with Audiolense.Lately, I'm using NUGEN Audio Halo Upmix on my M1 Mac mini. Last time I tried, I could not get it to load in Element, however, it works...
-
-
Hhulkss replied to the thread 2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?.Set your sub channel analog gain so that at 0 DBFS output from your audio interface the sub amp is at max rated output or at the max...
