Recent content by Horst

First- wish you and all here a happy new Year! Thanks i will read it and hope i understand :cool: lg

Hi what is the exact Difference between"RMS average" and "vector average" ? Thanks Alpi

My DOUBLE BASS ARRAY The delay of the first measurement of the left loudspeaker with the Java excl. I entered the driver at delay (-0.1044) at "timing / use acoustic timing reference". I made all of the following measurements with this timing reference. I would like to simulate my DBA based on...

ok thank you very much i will look what happens but it is not really a problem for me.

Unfortunately, this happens to me during a measurement session. Today I even had to restart the PC because the driver (CX-A5000) no longer appeared. Everything is running normally, everything is switched on and connected, but REW still loses the setting frequently.

Ok thank you very much for your tips. It often happens that REW loses the driver (Java excl. CX-A5000) and I have to select it again in the preferences. This is not a problem for me, but once i forgot to reselect the driver when it gave me the message and I continued to measure with the...

Thank you, does ASIO4ALL have advantages over Java exclusive? Which drivers do you use?

Here the mdat

I have now had time to measure, but REW makes different measurements with Java or ASIO4All, especially in the level. I calibrated the level with Java_default to 77.5db and with ASIO4All the measurement is different but especially different in level - 10db diff. Left LS large measured at...

Sorry I was not in the forum for some time. Thank you for the explanations, the calculations are based on the fact that the same material is used for absorption everywhere in the room? But what if I have a baffle wall at the front, the front area on the ceiling and the sides with absorbers (10cm...

I would be interested

Hi John, What absorption do I enter for e.g. 0.5m rock wool in the rear area? or for 1m rock wool? Special for 20 to 100Hz? Is there a table lg

OK thanks

Thank you then i will measure with Java the Excl. Mode. Do I have to pay special attention to the Windows settings since Java takes over the Windows settings? Or is that different now with the excl. mode?

Interference, strange slight crackling, irregular noise but with Java it is now good. You can see the fidgety curve with the impulse, just like with the SPL. Also the waterfall changes drastically with ASIO when changing the length (256 to 2M). With Java, the curves look more credible. However...