Recent content by filio

Thank you JT for this!!! I tried to get the same result but with no success till now. How did you please adjusted the impulse to 0ms?! You are right, I saw a timing offset of something like 22ms on the measurement panel, but not 45ms if I remember well. Further than this, I would have 2...

Hello Dan, Hello JT, Yes, Dan, I had a look ! It is very similar indeed! The first one who will find will help the other! Your amplitude graph is flatter I also see... For your information after too much correction, I came back to a lighter correction and it was more musical. But I know I will...

Please see hereunder

Hello from France, Maybe you are going to be of help, I measure my one way loudspeakers at sweep point (R+L together) and I found a phase going from +600° to -400° from 40Hz to 300Hz and then it is plus or minus flat up to 20 000Hz. Does it makes sense please? And how could I correct this...

My beginners questions are of help indeed! Thank you! Have a nice day and take care

I can change the measurement duration manually selecting "from file", browsing the desired file and them selecting "from REW", changing the length to 4M and then going back to "from file" but without browsing again the file. The duration time is then 21.8 seconds...

Yes, I do select "From file" as the playback mode and load the file on the Measure dialog.

I have V5.20 BETA 44 downloaded this afternoon (in France). The sweep was generated with the same version. Strange.

Hello, thank you, it does recognize it now! The signal does not climb to the yellow zone but to the top of the green. Maybe this is why? I still have a problem: the measurement is only 5.5s while the sweep is 23 seconds... I will try to solve it alone and do not bother you with this, Thank you...

Thank you, No sorry, I do measure loudspeakers! The timing references are on the same right channel (before and after the sweep, generated by REW), I clearly hear the timing reference on the loudspeaker (the right one). and while trying to measure the signal level climb to the yellow zone of...

Hello, When I start a measurement, REW wait for timing reference and does not recognize it. It does recognize a "timing reference" when the sweep high frequency are playing! For your information, I use a playback file (the same file I play on the headphones?). The file was previously generated...