Recent content by Faustchz

  1. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    Thanks, I will increase the sun volume then.
  2. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    Finally completed my first measurements! The reason for clipping when using UltraLite with ASIO was that the buffer size for the soundcard was too small. Increasing the buffer size resolved the issue. Still no luck with the UMIK-1, but the other mic works now so I can still precede without...
  3. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    1. When UMIK-1 is used, Audiolense says not supported. 2. When EMM-6 and Motu soundcard are selected, measurement can be started, but I can hear my speakers clipping and Audiolense would also report measurement unsuccessful. 3. My setup and cabling: EMM-6 to mic-in#1, line-out#9 to mic-in#2...
  4. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    Well, I run into several obstacles… 1. I had no idea using an soundcard and mic as input could be this complicated. As of now I am unable to conduct a successful measurement on either Audiolense or REW. I saw clipping, level too low, or other weird results. Why is that? 2. On Audiolense the...
  5. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    Thanks for your input, Herbert. I already bought the MOTU UltraLite mk5 and it works for me. I am actually glad that the MOTU has a pair of mic preamps in case the USB mic isn't working on Audiolense (and in my setup it just isn't).
  6. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    OK, I will give it another try tomorrow.
  7. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    Trying the Audiolense now. Seems like it doesn't support the UMIK-1? Had to buy another mic then, just ordered an EMM-6.
  8. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    Thanks, David. I was just looking at the UltraLite mk5. Seems like it does everything I need. The RME UCX II doesn't seem to be available yet in the US. I know Mitchco uses the Hilo but I would like a small form factor gear. I am waiting for a new measurement mic and other stuff so I am not in a...
  9. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    Thanks, Bernt. It seems like I should go get a 4 channel DAC. Off the top of my mind, I can only think of the miniDSP SHD which has 4 digital outputs and 4 analog outputs. It has too many added features, however, like Dirac and crossover, which can be replaced by Audiolense XO. Are there any...
  10. F

    2.2 Channel Hardware Requirement to run Audiolense XO (or 2.0)?

    Hello! Newbie here. My current setup is the following: MacBook Pro (Dirac Live Processor) --> Motu M2 audio interface --> two SVS SB4000 subwoofers --> two Genelec 8341 studio montiors. The M2 has two TRS outputs and two RCA outputs. The SB4000 has RCA and XLR inputs and outputs. It has an...
Top Bottom