Recent content by Dtune

Well, this thread is proving to be educational, but not exactly in the way I originally intended. Thanks to Moedra I have a more coherent system. If I only learned only one thing, it's that all settings are interdependent. Don't be afraid to experiment, analyze, listen, try again. Cornelis...

My room is made of logs and sounds very different than when I was in a drywall lined room. Also dimensions are generous. Sounds great. I actually adopted your last curve with a touch more rolloff at the top end. It's nice to be able to change the presentation with just a couple adjustments.

The sound is pretty transformative compared to listening without audiolense. I was certainly prepared for an improvement in the bass. What I wasn't prepared for was how good the correction sounds across the entire bandwidth. At one time I had a surround sound preamp with Audyssey built in...

Well I can't thank you enough. I can't say I fully understand this. Mitch has said in some posts to use a small time value (1-2ms) in CPD frequency correction when doing full (as opposed to partial) corrections so low values for high frequency correction was where I was headed. Just trying a few...

Nope That's amazing! Could you share the CPD settings and target? I knew about mixed phase targets but didn't really know how to configure them.

Zipped now, see if that works.

Yes I have already been through a few iterations and the results have improved. Very counterintuitive but a 4 octave crossover slope improved step response. I thought I had attached my measurement file. I'll do so again. Thanks.

Thanks for those Target curves and offer to help! Much appreciated. Two full range mains plus 4 stereo (2+2) subs. Here's my current setup. I'm trying to fill a 12 - 15 db hole around 50 hz without causing other issues. I have only one large tube trap in the room so that might need to be...

That does seem to be the approach of many. I was approaching this as a shared learning experience particularly with new users. That way when Mitch or Bernt refer to a particular target curve we could plug it in and experience that curve for ourselves. Then using the designer we could tweak it to...

Hi, could someone point to some saved target curves for Audiolense? My skill with mouse and little dots drawing precise curves leaves something to be desired. In the help file Bernt refers to various accepted Targets and Mitch does also in his various articles i.e. Harman curve, expert...