I have a denon 8500 and their eq app so I can do some changes, but I'm not usually a fan of audyssey for music so if I can avoid that I'd prefer to. I'll play around with everything again tonight. I did do a quick eq drop of everything over 5k 6db and voices and other sounds still sounded 95%+...
16x21x9, walls are 10" cement, ceiling 16" cement, floor 6" cement/dirt. All surfaces are polished/exposed concrete behind AT fabric façade. Ceilings 70% coverage of 4" 703, rear wall 50% coverage of 6" FR703, front wall fully covered 2" FR703. sides are 2" from floor to 6" above ear level. 2x2...
Is there a way to detect "harshness" with REW? Perhaps in impulse response or some other test? I'm trying to determine if/what I can do for crossover in the speaker or bi-amp, or if I'm our of luck because it's the natural behavior of an AMT tweeter or phase plug woofer.
I recently upgraded my...
Sorry, I should have attached logs to be more helpful than 'it's just broke'.
Feb 11, 2021 11:50:49 AM roomeqwizard.RoomEQ_Wizard main
INFO: REW V5.20 running JRE 1.8.0_282 64-bit on linux 4.4.0-201-generic, en, US, UTF-8 at 96 DPI
Feb 11, 2021 11:51:03 AM roomeqwizard.DD A
SEVERE: Timed out...
I b-tree tested all beta versions to find out where/which version audio broke. It's actually recent where the issue began. RC2 works fine, RC3, RC4 and RC5 do not. I checked change log and I don't see anything that stands out, although I did try different sample rates in Preferences and...
To start, 5.19 works great and I don't have any issues with it. I can even switch back to .19 after trying .20 RC5 and .19 works so .20 RC5 is not locking up a buffer or causing an IO, driver or system issue. In fact, .20 RC5 shows it's outputting audio fine when doing measurements (in the REW...
I tried RC5 tonight but never could get it to output audio from my Linux laptop. .19 works so I'm not sure what's going on yet. I switched to my wife's windows laptop and hit another block where asio4all would change which channel/speaker it was outputting audio to. 1.1 would sometimes to go...
Thanks for the review, that was extremely helpful and I'll continue on with your suggestions. I spent all last night reading more about the differences and pieces of each REW graph and the purposes of them. I had used REW about 10 years ago but not very in-depth as I'm trying to now. I have a...
I've measured my 7 bed layer of my 7.1.6 (Denon X8500H) 3 times. Without Audessey, Flat, and Ref(erence). I'll note that I need to investigate why Flat and Reference are killing highs on my RSL, RSR and Center (odd...) but without Audyssey active the speakers don't have the drop out above 10k...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.