Recent content by Daren

Hi Tony. I made sure I had the latest firmware. However, I have been given an answer by someone in another forum. They said it's a design quirk. The actual display only has the following icons: HL--------HR FL---C---FR SL-SW-SR SBL-----SBR That's it. They pointed out that the display says...

I have reached out to Onkyo support as well. I was just hoping someone with this unit had 4 ATMOS speaker setup and could confirm for me that it either shows up correctly on the front display or doesn't.

Correction from above. My Height Channels are ONLY connected to the Height channel terminals. My two surrounds are connected to the surround channels. To answer your question did you see my posted picture? It doesn't show on the display in front that the rear height channels are connected...

I have gone through auto-calibration and yes on the configuration screen set it to 5.1.4. Also, when I run the test tones it shows on that screen the correct configuration on that screen too. As I stated when playing ATMOS sound is coming out of all the speakers when I play an ATMOS source.

I just bought this and I think a couple quirks are annoying but it’s a really good receiver. I don’t like that you have to hit the info button just so you can see the audio information. Also, I believe this is a quirk but in my 5.1.4 setup (front and back height speakers) the Onkyo display is...