Recent content by Countcobolt

Hi all, continuing my endeavour on making things right :) . Most of the things seem to be OK yet I am expanding my setup with a FBQ1000 and Tannoy reveal speakers as a B set. Adam is my A set. So one general question: 1. stupid question: the ECM8000 , do you put it in a 90 degree angle or...

Hi Wayne, I think the change was a bit exagerated when I move. I don't hear it, but I measure it. Think the main difference between hearing and seeing :). What I have done at the moment is the following: I took the same 7 spots I measure in ARC2. I measured L and R separately. I did the...

Hi Wayne, John I redid all the measuring. I was able to add 10 filters and get to a very close flat response. I did notice that the Midi did not function properly when I send the info to the FBQ. I do believe this is not the software but the Roland Midi USB converter with forced drivers. A new...

Hi John, Wayne thanks for responding: I took a different approach today and eureka! 1. I think my ECM8000 is broken. I measured with the ARC2 microphone as ARC claims it is a flat response microphone. The measurements seem way more correct. 2. First I changed the rear speaker settings a lot. I...

Hey Wayne, I think I get the idea. I am surprised that REW is giving me those results as I used this room for mixing several CD's. I did not measure the speakers separately but combined. You articles did make sense to me a lot. I will try to "hear" the difference as I was really looking at...

Hi Wayne started from scratch today. First measurement (disabled the ECM calbiration as this is supposed to be flat) Then I tried the following as filters Which result in the following predicted curse (That would be awesome) Unfortunately when I measure again, the predicted and the...

HI Wayne, I'll try to perform the following. I'll start from scratch on the measurements. Next I will apply the EQ corrections to go as close to the target line. Then I will remeasure after the correction. I will use 1/3 scaling. After that I will upload the MDAT files and the pictures. Kind...

Hey Wayne In the first pic the dark red line is the actual measurement. The light red line is the "prediction". The green one in the second pic is the result when I apply the prediction EQ to the FBQ. Hope this helps Kind regards Steve

Hi Wayne what surprises me is that when you look at the below graph the dark red is my measurements (FBQ on bypass) . The light red are my correction: One would assume that these setting would give me too much mid and too much high. Yet on the second image you see the measurements after...

Hi all, I am trying to measure my studio for better sound performance. Let me first describe my setup: I am running a focusrite Scarlett 18i20 hooked to a FBQ2496 to 2 ADAM A7X speakers. On the speakers there are small modifiers for sound, but I placed them all to flat. I am trying to set up...