Recent content by climbclimb

There is continued oddities with the impulse. There is a big delay between speakers - I found when I swap the external crossovers (changing nothing else), the delay moves with those. I know it's weird for an XO to delay by more than a wavelength, but there must me something else in there...

Thank! - here is the correction procedure designer settings: The corrected impulse response looks (oddly?) squashed and I'm not sure why there's the amplitude difference between left and right when the overall response is similar.:

Making progress. Curious why there is the remaining dip in the upper midrange of one speaker, especially when they measure similarly in that range. Allowing up to 8dB correction. Relevant to this, I'm not sure how the target is scaled(or not) to the measurement.

Turns out windows volumes affect the overall volume for WASAPI - the coefficient is just so much smaller than I'm used to. Oddly, now I can easily send my 9040sa amps into protection mode without getting too loud. Tried doing a 5s sweep from 30Hz, thinking there was overall less energy going...

thank you - I actually did set the measurement level all the way to max (0dB).

Audiolense made some great filters for my last speakers (thank you, Mitch). Now trying it on my own for new laptop+speakers. When attempting to run sweeps through audiolense 6.21, I'm seeing very low output from the speaker (maybe 70dB) Measurement setup is windows, UMIK-1 microphone, to...