Recent content by Cintaku

Could John or Glenn put a bit more light on this? I have calibrated Steiner Amplifier (patch cable IN with phantom switch ON and 4.5m cable connected to R output) and the curve is beautiful flat (only -1dB at 20Hz and -1dB at 20kHz). I was able to set IN and OUT level at 12dB. Saved the file...

I purchased ECM 8000 microphone (without calibration file) and UM2U-Phoria pre-amp and REW software. Great. Following are fundamental questions: 1 - If you use XLR connector for microphone and you need to connect INPUT (XLR) & OUTPUT (1/4" TRS) I assume this is done by XLR/TRS1/4" patch cable...