Recent content by Bunandburger

The chart is showing only the sub measurements. Maybe I should sweep with the towers.

It was a flat pack that I assembled. I also finished them with a veneer and stained them. My wife wouldn’t allow them I. The living rooM if they were just MDF.

MiniDSP 2x4HD.

I have not run room correction yet. I was under the impression that I need to get the subs dialed in first.

1/4 and 3/4 across the front wall.

I have dual GSG Mini Marty subs with 18” Ultimax drivers. Each powered by their own Crown XLS 2002 (2100w bridged). My receiver is an Anthem MRX720. Attached is a photo. The red line is a raw measurement and the green is after a house curve was added. EQ seems to have no affect above 50Hz. I’m...

Hello, I'm new to all of this and I'm hoping that someone out there can help. Seems as though I have my subs aligned well, however after about 50Hz it pretty messy. I tried to apply EQ but it seems to have no affect. Can anyone help?

I was going to post this exact question. So, for subwoofer integration and alignment the Anthem mic is adequate without a cal file?