Recent content by boxerfan88

  1. B

    Help with step response

    Thank you very much for sharing your insights. Much appreciated.
  2. B

    Help with step response

    What is a reasonable time delay between woofer vs. subwoofer?
  3. B

    Help with step response

    I redid the measurements, keeping everything constant except for subwoofer delays. The main speaker is a 3-way active, and single subwoofer. The chart looks like this: ^ the red one has subwoofer delay of 5ms added in the digital crossover configuration. I have marked out the various peaks...
  4. B

    Help with step response

    Okay, so the vertical axis isn't that important I guess, since the peak is locked to 100%, everything else is scaled/displayed relative to the 100% peak.
  5. B

    Help with step response

    Dear all, I would be grateful if someone can shed some light why a step response so called "starting point" or "zero point" can be so far below zero. Refer to the attached image. Any feedback would be appreciated. Thank you very much.
  6. B

    Prayers for the Mulcahy family!

    My condolences to you, John, and your family.
  7. B

    V5.20.14 early access build

    I was playing around with RTA settings and hit this error. Not sure what I was doing to cause it...
  8. B

    V5.20.14 early access build

    Posting here some observations about the CAL settings that could explain the huge SPL offset. Mic Cal "gear" details (when there is a problem): Mic Cal "gear" details (after delete preferences-shutdown-reconfigure, and working properly): I am not sure how REW got into the "red box" state....
  9. B

    V5.20.14 early access build

    Hello @John Mulcahy @JoinUs It's okay now. I just did a "delete preferences & shutdown", and then reconfigured REW from scratch. Now it's all good. Imported graphs are at 76dB levels.
  10. B

    V5.20.14 early access build

    I'm sorry, I don't quite understand. Where do I check/set this "offset value" ?
  11. B

    V5.20.14 early access build

    Hi John, I am using 14ea64. Today I imported sweep recording, and the graph is at 125dB level, when it should be at around 76dB level. Not sure why this is happening. Is it some REW setting that I need to check? Attached is the MDAT, sweep recording, sweep source.
  12. B

    V5.20.14 early access build

    Thank you. I overlooked the new feature.
  13. B

    V5.20.14 early access build

    Hi John, I found some trouble with the latest build 5_20_14ea47. When I import sweep recordings, the distortion graph is all greyed out. It does not happen with 5_20_14ea39.
  14. B

    V5.20.14 early access build

    Hi John, After installing 5.20.14ea43, upon startup throws the following error: I reverted back to V5.20.14ea39, all good now...
  15. B

    Impulse Graph Question

    I see. Thank you.
Top Bottom