Recent content by Bobski321

Any input on the number of taps? Another question. Is there a way to increase the accuracy of the filter or correction? And I'm not just talking about Max boost. I know the filter is designed in a way to not be absolutely accurate, by considering psychoacoustics and I suppose be a little more...

So... Do most people just set filter length to 131k taps and call it a day? Is more generally considered better?

Super awesome info... really appreciate it.

The convolver is going through HQplayer where it also is upsampling everything to DSD512. The Buchardts are a remarkable speaker. Very small, but somehow manages to have decent bass extension with some punch.

I just use a umik-1 connected to a laptop.... something I'm looking into upgrading, but I'm not ready to spend the coin right now. My system consists of Qobuz, through Roon, through HQplayer, out USB into Holo Spring 3 KTE DAC, into Kinki Studio integrated, out to Buchardt s400 mk2 speakers...

So...when you say your target looks good, you didn't mention your opinion on how far down you would recommend to go with the bass before I complete the target. I'm really interested in people's experiences with that. I've tried the 50%/50% thing. Thought it sounded great, but I prefered...

So....when drawing a target curve, how low should you draw the bass drop off? I see most examples are at -30 or so. Do you have any recommendations? Or is it really just personal preference? As you can see, I went down to -42. Edit: I'm actually finding it sounds a bit better closer to -30.

But then wouldn't it just be better to use longer measurements then right? Maybe not necessary, but if you're saying sometimes it may be beneficial, then why not just use the higher number? What are the downsides of using higher measurements? The only thing I've observed is that the impulse...

This is great information, thank you. Just to finish off the measurement questions....I have one more. I'm slightly confused about the length of measurement. I would assume that the longer measurement would be more accurate... This is something I always did in REW. But it seems recommended...

Thanks so much for your reply. That's good to know. Another quick question.... Is a measurement that says "good dynamic range"... Inferior to one that reads out "excellent dynamic range"? Should I always have the volume that loud when taking measurements? Thanks again.

Hello Forgive my inexperience, but I do have some things I'm trying to figure out. I'm wondering if audiolense has a way to correct for phase issues caused by crossovers. I've used REW, and had to use re-phase to compensate for phase shifts. Does audiolense automatically do this? Thanks.

So…. You’re probably going to laugh, and say that these look pretty good, right? I actually did do a couple more and they did stay pretty much the same. Last time I experimented with this, I had a fairly large wideband driver…. And now I’m using a regular two-way bookshelf. Maybe that was why I...

Ok….I’ve basically figured that out. So, I’m finding the the numbers vary quite a bit. Say, I just keep doing that same process over and over again….without moving the speakers or mic, I’m getting different values. Is that normal? What kind of accuracy should be expected from this method...

Perhaps I don’t recognize the answer when I see it….but I’ve tried searching and it’s still confusing to me. All I want to do is try and time align my left speaker to my right speaker in a two channel stereo setup. Or at least check to make sure they are properly time aligned. Could someone...