-
-
LPerhaps an issue with your domain mail server Chips, I sent you a new upgrade code on 29th November and refunded the payment. I also...
-
LLid9497 replied to the thread Ground Loop.Currently dealing with similar problem, however I narrowed it down to ground loop. My subs are silent when nothing is connected, but as...
-
LLid9497 replied to the thread Unsure of the results of my efforts.Maybe too many filters with too high Q and boosts? That will make graphs look good, but will smear transients, leaving you with thin and...
-
LLid9497 replied to the thread Help: Why use a 20k Sweep for a Sub, and not just 20-80Hz?.My method: Use pink periodic noise for subwoofer(s) - Sub cal (30-80hz) to target dB (I use 75dB), use Speaker Cal (500-2000hz) for...
-
LLid9497 replied to the thread Crossover, speaker alignment, room equalization - what do I start with?.So I have been reading on causes of pre-ringing, learned there are different types of equalization processes, and apparently only...
-
LLid9497 replied to the thread Crossover, speaker alignment, room equalization - what do I start with?.Thanks, I listened to the first track (Rikimaru?) first in my headphones to get a good reference point, I then played in on my speakers...
-
LLid9497 reacted to Keith_W's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with
Like.
Why wait for me? :innocent: You saw it first! Anyway let's have a look. Here is a more sensible zoom of your FR with subwoofer (red)... -
LLid9497 replied to the thread Crossover, speaker alignment, room equalization - what do I start with?.Here is my mdat file :)
-
LLid9497 replied to the thread Crossover, speaker alignment, room equalization - what do I start with?.Hello, back with another update. I think I am finally finished, after 3 arduous months of positioning, measuring, optimizing - not a lot...
-
-
LLid9497 replied to the thread Crossover, speaker alignment, room equalization - what do I start with?.Hey, back with an update. I've finally found a good listening position where MSO has the most to work with. I measured two completely...
-
-
LLid9497 reacted to JStewart's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
It shouldn’t matter, but there’s no point in capturing a lot of noise. A few hundred Hz should be fine. To verify all is working...
-
LLid9497 replied to the thread Crossover, speaker alignment, room equalization - what do I start with?.I meant what measurement range do I use for MSO for subs only optimization purposes, I am not using it for mains eq. Thx for the links...
-
LLid9497 reacted to JStewart's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
I think @Lid9497 has used MSO to already set the subwoofers as a group and at this point needs to set subs group to the mains. If I’m...
-
LLid9497 reacted to sm52's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
The difference is not 1.2 ms, but 0.14 ms. The measurements of 200 and 500 are almost the same. The 20k measurement differs by 0.14ms...
-
-
Loading…
-
Loading…
