I would like to only run 1 mono amp for a 3 way DIY speaker. The only way I can find is to use a typical passive crossover. Now if you could do it with an electronic crossover you could calibrate with REW, and make your crossover easier (and make on the fly changes), but every where I look requires multiple amps.
Why couldn't you have a speaker level in (from a mono amp), and have speaker wire outputs to the individual drivers?
The only othercway I see to do it would be a analog crossover and use Dirac in front of a mono amp.
Why couldn't you have a speaker level in (from a mono amp), and have speaker wire outputs to the individual drivers?
The only othercway I see to do it would be a analog crossover and use Dirac in front of a mono amp.