JackT
Registered
Thread Starter
- Joined
- Jan 11, 2021
- Messages
- 3
More
- Preamp, Processor or Receiver
- Marantz 8802A
- Main Amp
- D-Sonic 5 channel amp
- Additional Amp
- NuPrime 8 channel amp
- Computer Audio
- Micro Zuma C.A.P.S
- DAC
- Marantz 8802A via HDMI or Oppo BD105 via USB
- Universal / Blu-ray / CD Player
- Sony UBP X700 and Oppo BD105
- Front Speakers
- Anthony Gallo Ref 3.5
- Center Channel Speaker
- Anthony Gallo Strada
- Surround Speakers
- Anthony Gallo Strada
- Surround Back Speakers
- Anthony Gallo Strada
- Front Height Speakers
- Anthony Gallo A'Diva SE
- Rear Height Speakers
- Anthony Gallo A'Diva
- Subwoofers
- 2x Seaton Sound F2
- Other Speakers or Equipment
- Synology NAS DS213
- Video Display Device
- Sony Projector VWL-675ES
- Screen
- 16:9 Stewart Filmscreen
- Streaming Subscriptions
- Amazon Prime & Netflix
Hello,
After a year plus of remodeling my media room I am able to start enjoying music and movies again. Today I brushed off my Audiolense skills and measured my room for 5.1 music. The measurements were successful and I created convolution filters for 44.1Khz to 352.8kHz. These files were created in .cfg and .wav formats. I then linked these new convolution files in JRiver version 29. Initially I linked them to the .cfg files as these switch automatically between sample rates whereas .wav files do not.
Any songs played through JRiver using those filters sounds all messed up. Out of sync and slowed down. When I link JRiver to the .wav files all seems good. I did notice that when linked to the .cfg files it shows 8 paths of processing whereas it shows 6 paths of processing when linked to the .wav files. JRiver is set up for 5.1 channels.
I am using Audiolense 6.17. All bass is sent to the subwoofer. I am using a Marantz 8802A processor linked to my pc with an HDMI cable. I have attached the .cfg files for reference. Maybe you are seeing something I am missing.
Thanks for reading.
Jack
After a year plus of remodeling my media room I am able to start enjoying music and movies again. Today I brushed off my Audiolense skills and measured my room for 5.1 music. The measurements were successful and I created convolution filters for 44.1Khz to 352.8kHz. These files were created in .cfg and .wav formats. I then linked these new convolution files in JRiver version 29. Initially I linked them to the .cfg files as these switch automatically between sample rates whereas .wav files do not.
Any songs played through JRiver using those filters sounds all messed up. Out of sync and slowed down. When I link JRiver to the .wav files all seems good. I did notice that when linked to the .cfg files it shows 8 paths of processing whereas it shows 6 paths of processing when linked to the .wav files. JRiver is set up for 5.1 channels.
I am using Audiolense 6.17. All bass is sent to the subwoofer. I am using a Marantz 8802A processor linked to my pc with an HDMI cable. I have attached the .cfg files for reference. Maybe you are seeing something I am missing.
Thanks for reading.
Jack
