Verification of correction filter

jhenderson0107

Registered
Thread Starter
Joined
Oct 18, 2017
Messages
3
The signal flow in my system is Roon -> Raspberry PI USB -> Topping D10B SPDIF-> Benchmark DAC -> Linkwitz Orion 3-way analog XO -> Power amplifiers -> speakers. When using AL to measure the system, a laptop running AL 6.17 replaces the Raspberry PI and a mini-DSP UMIK is used to capture response data. Is there a way to verify the performance of the generated convolution filter within AL 6.17 using the laptop following the measurement process? In other words, I'd like to activate the convolution filter within Audiolense, perform another measurement and verify the actual system performance rather than rely on the predicted response.
 
Last edited:

hulkss

Active Member
Joined
Feb 12, 2020
Messages
213
The most reliable way is to export measurement sweep files from REW and play them in Roon just like regular music playing through the convolver. REW can "listen" for the measurement sweep and record a measurement. This way you can verify your exact playback setup.
 
Top Bottom