Phase Exporting Issues

soho54

Registered
Thread Starter
Joined
Sep 20, 2018
Messages
2
Using REW v5.19

When I am exporting a measurement as a txt file the phase is only reported for the first part of the file and then "?" are added for the rest.

Unwrapping the phase doesn't help either. It just changes the values over the same spread.

Say from 500 to 20K I get phase data up to 803.5 then "?" on up.

Inside REQ the phase is there for the whole sweep on all measurements and windows like it should be.

Any ideas? What am I missing?
 

soho54

Registered
Thread Starter
Joined
Sep 20, 2018
Messages
2
OK, it seems it was the smoothing option upon export. If I set it to anything but the 1/6 through 1/48 smoothing I get the full phase response.

I didn't need the smoothing anyway. If anyone else is getting hung up on it like I was just remove all smoothing at export. Smooth it on the other end.
 
Last edited:

John Mulcahy

REW Author
Joined
Apr 3, 2017
Messages
7,212
Download 5.19 again and re-install it, then do "Apply Windows" (in the IR Windows dialog). The initial build had a bug that was fixed a couple of days later.
 
Top Bottom