OLD REW OS X DMG (includes private Java 8 JRE)

REW Beta Release OLD REW OS X DMG (includes private Java 8 JRE) V5.19 beta 8

You Must Login or Register to Download

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
John Mulcahy submitted a new resource:

V5.19 beta 5 OS X DMG (includes private Java 8 JRE) - OS X 10.7 - 10.12

V5.19 beta 5 21st May 2017

  • Added Outlaw Audio Model 976 equaliser setting
  • Added a stepped sine distortion measurement capability to the RTA
  • Added configurable distortion high pass and low pass filters to the RTA controls to exclude content outside the chosen frequency span
  • Highest distortion harmonic for sweep measurements changed to 9th, same as RTA
  • Added a control for the highest harmonic that will be used when calculating THD
  • Added buttons in the All SPL controls...
Read more about this resource...
 

Arnaud Kabore

New Member
Joined
May 23, 2017
Messages
2
My AV System  
Preamp, Processor or Receiver
MIdas
Main Amp
Crown cdi 1000
“Room EQ Wizard Installer” is damaged and can’t be opened. You should eject the disk image.

El capitan 10.11.04
 

Sonnie

Senior Admin
Staff member
Joined
Apr 2, 2017
Messages
2,504
Location
Alabama
My AV System  
Preamp, Processor or Receiver
NAD M17 V2 Processor
Main Amp
Emotiva XPA-1 Gen 2 Monoblocks
Additional Amp
Emotiva XPA Seven
Other Amp
Emotiva A-150
Universal / Blu-ray / CD Player
Panasonic UB9000 4K UHD Player
Front Speakers
MartinLogan Classic ESL 9
Center Channel Speaker
MartinLogan Focus C-18
Surround Speakers
MartinLogan ElectroMotion ESL
Surround Back Speakers
MartinLogan Motion 12
Front Height Speakers
MartinLogan EM-IC
Rear Height Speakers
MartinLogan EM-IC
Subwoofers
SVSound SB16-Ultra x 4
Video Display Device
Epson 6050
Screen
Elite Screen
Remote Control
Universal MX-890
Other Equipment
Dish Joey 4K
Have you tried downloading it again?

There have been approximately 30 downloads with no issues reported.
 

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
Check that System Preferences -> Security & Privacy -> General is set to allow apps downloaded from Mac app store and identified developers and not just Mac app store.
 

Arnaud Kabore

New Member
Joined
May 23, 2017
Messages
2
My AV System  
Preamp, Processor or Receiver
MIdas
Main Amp
Crown cdi 1000
That did the Trick!!! Thanks a Million!!!
 

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
John Mulcahy updated V5.19 beta 5 OS X DMG (includes private Java 8 JRE) with a new update entry:

REW OS X DMG (includes private Java 8 JRE)

Changes in beta 6:
  • Play a minimum level sine wave before the sweep starts to help with signal lock for digital connections e.g. HDMI
  • Capture the noise floor before sweep and stepped sine measurements
  • Added option to mask distortion harmonics that are below the noise floor (on by default)
  • Show harmonics used in THD calculation in trace name
  • When saving filter coefficients to file for Generic equaliser only include enabled filters
  • Faster operation of the right click...
Read the rest of this update entry...
 

freqhunter

New Member
Joined
Aug 11, 2017
Messages
3

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
Please check the log files to see if errors have been logged, their location is shown in the About REW dialog. Were the input levels normal during the calibration?
 

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
Thanks Stefan - could you explain what was configured incorrectly? Even if something is not as it should be REW should not just get stuck, so I'd like to make sure the problem you had is handled better.
 

freqhunter

New Member
Joined
Aug 11, 2017
Messages
3
Hello John, no problem:

In 'Preferences' -> 'Analysis' 'No timing reference' had been pre-selected. After changing to 'Use loopback as timing reference' i could continue with the measurement.

Kind regards, Stefan
 

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
Thanks. Not sure why that should have stopped REW from completing the measurement. The timing reference isn't used or needed for the soundcard calibration. It is possible the channel you had selected as the input isn't the channel the calibration loopback was connected on, when you selected 'use loopback as timing reference' the test signal gets output on both channels so a signal would then have appeared on the measurement input. That would have been apparent on the In and Ref In level meters though.
 

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
John Mulcahy updated REW OS X DMG (includes private Java 8 JRE) with a new update entry:

V5.19 beta 7 OS X Installer

Quite a few changes in this beta version, I'll list them here and make further posts to explain the changes.
  • Added ability to import sweep recordings and generate measurements from them
  • Added sweep level, timing ref level and sample rate selection when saving measurement sweep to WAV file
  • Added sweep settings information into measurement sweep files saved as WAV
  • Added option to capture spectrum data when making stepped sine measurements, the data can be viewed on...
Read the rest of this update entry...
 

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
John Mulcahy updated REW OS X DMG (includes private Java 8 JRE) with a new update entry:

V5.19 beta 8 REW OS X DMG

Changes in beta 8:
  • Reduced waterfall controls width to help formatting on low resolution screens
  • Added a View preference to show or hide the toolbar, hiding it makes more space on low resolution screens
  • Added a welcome message on startup with pointers to initial steps
  • RTA graph images captured with distortion panel showing also include the RMS level panel
  • Added 50 Hz as a 1/3 octave step for RT60 and Filtered IR
  • Added new controls for the filter frequency on the...
Read the rest of this update entry...
 

John Mulcahy

REW Author
Thread Starter
Joined
Apr 3, 2017
Messages
2,386
Try changing the name of the Java preferences file ~/Library/Preferences/com.apple.java.utils.prefs.plist

If that fixes the problem please email a copy of the renamed file to feedback@roomeqwizard.com
 
Top Bottom